15
Device malfunctions
Problem Cause Remedy
Is the mains cable plugged
properly in the socket?
Plug the mains cable into the socket
properly.
Device does not
work
Does the motor not start when
paper is inserted?
Slide the paper in the respective slot
so that it touches the sensor in the
centre.
Device does not
work after lengthy
operation or stops
during operation
Was the device in constant
operation for some time?
Is the surface of the device
warm?
Pull out the mains plug from the
socket and allow the motor to cool
down to room temperature.
Jam Have you inserted more than
6 sheets of paper (70 g/m²) or
more than 1 CD/credit card?
Has the material not been
inserted straight in the in-feed
slot?
Set the sliding switch to
REV to push back the paper. Switch
the device to AUTO again to shred
the paper remaining in the cutting
unit.
If you cannot rectify the fault yourself, contact your dealer or call the Olympia hotline.
Disposal Notes
This symbol [the crossed-out wheeled bin/PICTURE] means that the
product should be brought to the return and or separate collection systems
available to end-users, when the product has reached the end of its lifetime.
This symbol applies only to the countries within the EEA (*).
(*) EEA = European Economic Area, which comprises the EU Member
States plus Norway, Iceland, and Liechtenstein.
Guarantee
In the case of a defect, please return the device together with the receipt and
original packing material to the point-of-sale.
To Next Page
Loading...
