6
R
Paper Guide
1. Unlock the lock [3] which fixes the paper
guide [4].
2. Slide the paper guide [4] carefully on the
rail.
Note: Do not slide the paper guide [4] if the
lock [3] has not been released.
3. Position the paper guide [4] with the aid of
the positioning lines and measuring sys
tems [5].
Note: The paper guide [4] can be continually
adjusted on the rail.
4. Lock [3] the paper guide [4]. The paper
guide [4] then serves as a stop for the pa
per to be cut.
Trimmer
1. Set the cutting unit down on a level, stable
working base.
Attention: Risk of injury! The trimmer
blade is very sharp! Never take hold of
the trimmer blade.
2. Slide the cutting head [1] to one end of the
rail.
3. Slide the material to be cut under the guide
rail [2] and against the paper guide [4] and
hold the material to be cut in place with the
flat of the hand.
4. Press the cutting head [1] down lightly and
slide the cutting head [1] along the guide
rail [2] to the other end.
5. Remove the material cut.
Note: Only slide the cutting head [1] back to its
starting position after having removed the cut
material.
To Next Page
Loading...