126
Chapter 10
Troubleshooting (Cont.)
POSSIBLE CAUSES CORRECTIVE ACTION
REF. PAGE
1 The flash is pushed
down.
2 The subject is lighted.
3 The drive mode is set
to auto-bracketing.
4 The drive mode is set
to sequential shooting
or AF sequential
shooting when using
the Red-Eye Reduction
or Night Scene With
Red-Eye Reduction
flash mode.
5 You are recording
movies.
6 Panorama shooting is
set.
1 Press the flash switch to
raise the flash.
2 Set the flash to Fill-In mode.
3 Press DRIVE to change to
single-frame shooting.
4 Press DRIVE to change to
single-frame shooting.
5 Set the mode dial to any
position other than .
6 Cancel the Panorama mode.
P. 62
P. 62
P. 71
P. 71
P. 44
P. 75
The date recorded with the image data is wrong.
1 The date is not set.
2 The camera has been
left for too long with the
batteries removed and
the date/time setting
was canceled.
1 Set the date. The clock
adjustment is not factory-
preset.
2 Set the date again.
P. 29
P. 29
Your customized settings have been canceled.
1 You turned off the
power without saving
the settings.
1 Set ALL RESET to OFF.
P. 104
The flash does not fire.
To Next Page
Loading...
