Y PRECAUTIONS mm
~ng, always inspect batteries carefully for leaks, discoloration, warping, or any
nality.
iMH batteries (optional with certain models) are intended for use only with
(ital cameras. Never use these batteries with any other device.
.ge NiMH batteries (optional with certain models) before using them for the first
ey have not been used for a long pertod.
ge sets of batteries (optional with certain models) (2 or 4) together.
3y become hot during prolonged use. To avold minor burns, do not remove them
after using the camera.
alkaline batteries unless it is absolutely necessary. In some cases, alkaline
%y have a shorter service life than NIMH or CR-V3 lithium battery packs. Alkaline
ormance is limited, especially at low temperatures. The use of NiMH batteries IS
ed.
ese (Zinc-Carbon) batteries cannot be used with this camera.
sting the camera with battery power at low temperatures, try to keep the camera
jatteries as warm as possible. Batteries which run down at low temperatures may
after they are warmed at room temperature.
ded temperature ranges for NiMH batteries:
0°C to 40°C (32°F to 104°F)
..,,,,,.......,,,,.....,,............ 0°C to 40°C (32°F to 104°F)
-20°C to 3O”C(-4°F to 86°F)
‘glng, or storing the batteries outside these ranges could shorten battery life or
ry performance. Always unload the batteries from the camera before storing the
a long period.
g NiMH or NiCd batteries, always read the provided InstructIons.
?r of pictures you can take may vary depending on the shooting conditions or
ng on a long trip, and especially before traveling abroad, purchase an ample
extra batteries. The recommended batteries may be difficult to obtain while
l
Do not point the viewfinder toward strong light, like the sun. This may damage the inside
of the viewfinder.
l
Do not push the momtor forcibly; otherwise the image may become vague, resulting in a
Display mode failure or damage to the monitor.
l
A strip of light may appear on the top/bottom of the monitor, but this is not a malfunction.
l
When a subject is viewed diagonally in the camera, the edges may appear zigzagged on
the monitor. This is not a malfunction; It will be less noticeable in Display mode.
l
In places subject to low temperatures, the backlight may take a long time to turn on or its
color may change temporarily. When using the camera in extremely cold places, it is a
good idea to occasionally place it in a warm place. A backlight exhibiting poor
performance due to low temperatures will recover in normal temperatures.
l
The backlight built into the monitor and control panel has a limited service life. When the
monitor gets dark or flickers, consult your nearest Olympus dealer (Repairs will not be
free after the warranty expires).
l
The LCD used for the viewfinder or the monitor is made with high-precision technology.
However, black spots or bright spots of light may appear constantly on the LCD Monitor.
Due to its characteristics or the angle at which you are viewing the monitor, the spot may
not be uniform in color and brightness. This is not a malfunction.
To Next Page
Loading...
