15
En
Power on/off
Date/time setting
1 Before turning the camera on, press
the tabs on the lens cap to remove it.
2 Press the power switch to turn on the
camera.
● The lens moves out when the mode
dial is not set to .
● The monitor turns on.
● To turn off the camera, press the power
switch again.
● If the date/time has been returned to
the factory default setting, "Y/M/D"
appears on the monitor
Lens cap
1 Set the mode dial to , then press the POWER switch to turn on
the camera.
2 Press .
● The top menu is displayed.
3 Press Ñ on the arrow pad to select .
4 When is selected on the screen, press Ññ to select the date
format.
● Select any one of the following formats:
D-M-Y (Day/Month/Year)
M-D-Y (Month/Day/Year)
Y-M-D (Year/Month/Day)
● This step and the following steps show the procedure used when the date
and time settings are set to Y-M-D.
5 Press í to move to the year (Y) setting.
6 Press Ññ to set the year. When the year is set, press í to move to
the month (M) setting.
● Repeat this procedure until the date and time are completely set.
● To move back to the previous setting, press
É.
● The first two digits of the year cannot be changed.
7 Press .
● For a more accurate setting, don't press until the clock hits 00 seconds.
The clock starts when you press the button.
8 To turn the camera off, press the POWER switch.
● The lens retracts.
1 C725UZBasic-E1 04.2.19 1:42 PM Page 15
To Next Page
Loading...
