Olympus Camedia C-725 Ultra Zoom - Page 34

 Playback on a TV
1
Make sure that the TV and camera power are off .
2
Connect the camera to the TV using the video cable.
3
Set the mode dial to and press the POWER switch. Turn on the
TV. Set the TV to the video input mode.
● For details on switching to video input, refer to your TV's instruction
manual.
4
Select an image by using the arrow pad.
● The selected image will be displayed on the TV.
Mode dial
setting
Connect to the TV's video
input (yellow) terminal
Video cable
Connect to the
VIDEO OUT jack.
● Video signal is either NTSC or PAL compatible depending on the standard
in the intended area of distribution.
Note
34
PLAYBACK (Cont.)
En
4
Press to start formatting.
● A bar is displayed to show the progress of formatting.
● To cancel formatting, select NO in step 3 and press .
● All existing data stored on the card is erased when the card is formatted.
Make sure that you save or transfer important data to a PC before
formatting a used card.
Note
1 C725UZBasic-E1 04.2.19 1:42 PM Page 34