To disconnect the camera
1
2
3
Make sure that the card access lamp has
stopped blinking.
Make the following preparations for
disconnecting the USB cable.
Windows
1_. Click the "Unplug or Eject Hardware" icon _ in the
system tray.
%. Click the message that is displayed.
When a message is displayed saying that the hardware
can be ejected safely, click "OK".
Macintosh
_. The trash icon changes to the eject icon when the
"Untitled" or "NO NAME" icon on the desktop is dragged.
Drag and drop iton the eject icon.
Disconnect the USB cable from the camera.
Card access lamp
Note
• Windows: When you click "Unplug or Eject Hardware", a warning message may be
displayed. Make sure that image data is not being downloaded from the camera and that att
applications are closed. Click the "Unplug or Eject Hardware" icon again and disconnect the
cable.
For detailed operations of OLYMPUS Master, refer to the quick start guide }
displayed upon startup or the help of the OLYMPUS Master.
J
co
>-
0
5
38 EN
This camera is compatible with USB mass storage. You can connect the camera to your
computer using the USB cable provided with the camera to download and save images
without using OLYMPUS Master. The following environment is required to use the USB
cable to connect the camera to your computer.
Windows: Windows 2000 Professional/XP Home Edition/XP ProfessionallVista
Macintosh: Mac OS X v10.3 or later
Note
• Ifyour computer is running Windows Vista, you can setect [PC] in Step 3 on P. 36, press E>,
and setect [MTP] to use Windows Photo Gattery.
• Data transfer is not guaranteed in the following environments, even if your computer is
equipped with a USB port.
• Computers with a USB port added by means of an extension card, etc.
• Computers without a factory-installed OS and home-built computers
To Next Page
Loading...
