The camera not turn on even a battery
does when is loaded
The battery is not charged
• Charge the battery with the charger.
The battery is temporarily unable to function because of the cold
• Battery performance declines in tow temperatures, and the charge may not be sufficient
to turn on the camera. Remove the battery and warm it by putting it in your pocket for a
white.
The card be used
cannot
Sometimes when the contact area of the card is dirty, the camera cannot recognize the card,
and the [CARD SETUP] screen will be displayed. In this case, select [CLEAN CARD] and
after pressing [], take out the card, and wipe the contact area with a soft, dry cloth.
6")
No picture is taken when the shutter button is pressed
The camera is in sleep mode c_
• To save battery power, the camera automatically goes into sleep mode and the monitor
turns off if there is no operation for 3 minutes when the camera is turned on. No picture is
taken even if the shutter button is fully pressed in this mode. Operate the zoom lever or _"
other buttons to restore the camera from sleep mode before taking a picture. Ifthe camera
is left for another 12 minutes, it automatically turns off. Press POWERto turn the camera
on. O
The mode dial is in the position of GUIDE
• No pictures can be taken when the shooting guide is being displayed. Take pictures after o
selecting the settings by following the shooting guide, or turn the mode dial and set it to a
shooting mode other than GUIDE.
The flash is charging
• Wait until the _. (flash charge) mark stops blinking before taking the picture. _"
The date and time have been
not set
The camera has been used in the same condition from the time of purchase
• No date and time have been set in the camera at the time of purchase. Set the date and
time before using the camera.
"Set the date and time" (P. 7), "(_) Setting the date and time" (P. 29)
The battery has been removed from the camera
• The date and time settings witt be returned to the factory defautt settings if the camera is
left without the battery for approximately 1 day. If the battery is in the camera for a short
period of time, the date and time setting witt be reset earlier than this. Before taking
important pictures, check that the date and time settings are correct.
EN39
To Next Page
Loading...
