EasyManua.ls Logo

Olympus FE-360 - Page 31

Olympus FE-360
61 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Menus for Other Camera Settings
Erasing data completely Adjusting the CCD and the image
[MEMORY FORMAT]/[FORMAT] processing function [PIXEL MAPPING]
_ Before formatting, check that no important
data is left in the internat memory or card.
_ Non-Olympus cards and cards that have
been formatted by a computer must be
formatted with this camera before use.
Completely erases the image data
YES in the internal memory* or card
(including protected images).
I'4 Cancels formatting.
Be sure to remove the card before formatting the
internal memory.
Copying images in the internal memory
to the card [BACKUP]
This function has already been adjusted
at factory shipping, and no adjustment is
needed right after purchase. Approximately
once a year is recommended.
_ For best results, wait at least one minute
after taking or viewing pictures before
performing pixel mapping. If the camera is
turned off during pixel mapping, be sure to
pedorm it again.
To adjust the CCD and to adjust the
image processing function
Press the _ button when [START]
(Submenu 2) is displayed.
®The camerachecksand adjuststheCCDandthe
imageprocessingfunctionat thesametime.
......._T BE!UP _ BAGKUR ....................................................Turning on the camera with the _/_
YES Backs up image data in the
internal memory to the card.
Cancels the backup.
_[} It takes some time to back up data. Check
that the battery has sufficient power before
starting the backup.
Changing the display language [_S]
....... ...............................................................................................
or _ button [_/_]
_TsE!ue _!_
Pressing _/_ turns on the
camera and starts the camera in
YES the shooting mode.
Pressing [] turns on the camera
and starts the camera in the
playback mode.
The power is not turned on. To turn
on the camera, press the POWER
button.
_ "Changing the display language" (p. 13)
The language for the menus and
Languages _ error messages displayed on the
monitor is selected.
The available languages vary depending on the
country and/or region where the camera was
purchased.
EN

Other manuals for Olympus FE-360

Related product manuals