je Tips
If the camera does not work as intended, or if
an error message is displayed on the screen,
and you are unsure of what to do, refer to the
information below tofix the problem(s).
_ _ ili _
Battery
"The camera does not work even when
batteries are installed'.
• Insert recharged batteries in the _orr#c ! direction.
"Charging the battery" (p. 10) , "Loading the
battery (supplied) and the xD;Picture CardTM
(sold separately)into the camera'; (p: 11) ............
• Battery performance may have been reduced
temporarily due to low temperature. Take the
batteries out of the camera, and warm them by
putting them in your pocket for a while.
Monitor
"Difficult to see".
® CondensatiotY _may have occurred. Turn offthe
power, and wait for the camera body t5 6e_ome
acclimated to the surrounding temperature and dry
out before taking pictures.
"_ Dew drops can form in the camera when it is
suddenly taken from a cold location into a warm,
humid room.
"Vertical lines appear on the screen".
® This condition may occur when the camera is
pointed at an extremely bright subject under a
clear sky and so on. The lines do not appear,
however, in the final image.
"The light is caught in the picture".
® Shooting with flash in dark situations results in
an image with many flash reflections on dust in
the air.
i!i_!_ _iiii_ ii_i__!!!
ij lI Oa an, time nc.onii k Ji iiiiiii ! i iiiii i!!!;i! i!i ! i ii iii!!!ii i!iiiiii
default"Dateandsetting,,.timesettings ' ......
Card/Internal memory
"Anerrormessage_sd_p!_y_'!_
"Error message" (p. 42)
< ....
Shutter button
"No picture is taken when the shdtter
button is pressed".
• Cancel sleep mode ..........
To save battery power, the camera automatically
goes into sleep mode and the monitor turns off
if there is no operation for 3 minutes when the
camera is turned on. No picture is taken even if
the shutter button is fully pressed in this mode.
Operate the zoom buttons or other buttons to
restore the camera from sleep mode before taking
a picture. If the camera is left for another I2
minutes, it automatically turns off. Press POWER to
turn the camera on.
® If the batteries are removed and left out of the
camera for about a day"2,the date and time
settings return to the default setting, and must
be reset.
-2 The time until the date and time settings return
to the default setting varies depending on how
long the batteries have been loaded.
"Setting the date and time" (p. 13)
• Press _/_ button to set a shooting mode.
• Wait until _.(flash charge) stops blinking before
taking pictures.
EN
To Next Page
Loading...
