10
EN
Preparing the Camera
Insert the battery by putting in the ▼
marked side fi rst, with the B (FE-4040)/
C (FE-4020/X-940) mark toward the battery
lock knob.
Damage to the battery exterior (scratches,
etc.) may produce heat or an explosion.
Insert the battery while sliding the battery
lock knob in the direction of the arrow.
Slide the battery lock knob in the direction
of the arrow to unlock, and then remove the
battery.
Turn off the camera before opening the
battery/card compartment cover.
When using the camera, be sure to close
the battery/card compartment cover.
Insert the card straight until it clicks into
place.
Do not touch the contact area directly.
3
2
11
This camera allows the user to take pictures
using the internal memory even when no
SD/SDHC memory card (sold separately) is
inserted. “Using an SD/SDHC memory card”
(p. 47)
“Number of storable pictures (still images)/
Continuous recording length (movies) in the
internal memory and SD/SDHC memory
cards” (p. 49)
To remove the SD/SDHC memory card
12
Press the card in until it clicks and comes
out slightly, then grab the card and pull it
out.
Inserting the battery and the
SD/SDHC memory card (sold
separately)
Always use SD/SDHC memory cards with
this camera. Do not insert any other types of
memory card.
1
2
11
Battery/card compartment cover
2
Write-protect switch
Contact area
FE-4040 FE-4020/X-940
Battery lock knob
To Next Page
Loading...
