10
Connection
Connection to EVIS Video System
RGB/COMPONENT B connectors
RGB/COMPONENT A connectors
Monitor cable
Monitor remote cable
Monitor INPUT/OUTPUT connectors
R
G
B
S
N
Y/C
1 Connect the monitor cable to the MONITOR connector
of the video system center.
2 Connect the end of the monitor remote cable (MAJ-
227) labeled “MAJ-227” to the MONITOR REMOTE
connector of the video system center as shown in the
figure.
3 Connect the monitor cable to this unit as shown in the
figure.
4 Connect the end of the monitor remote cable labeled
“to OEV” to the REMOTE 1 connector of this monitor.
— Connect the R/G/B/S connectors to the RGB/
COMPONENT A connectors of this monitor. If they are
connected to the RGB/COMPONENT B connectors, the
Monitor Remote Control will not function.
— When the monitor remote cable is connected to the
EVIS video system center and you press the SELECT
switch on the front panel, some front panel switches
(RESET, UNDER SCAN, OVERSCAN and SPLIT)
will not function.
LINE A
LINE B
IN OUT
OUT
IN OUTOUT
VIDEO AUDIO
AUDIO
AUDIO
AC IN
R/R–Y G/Y B/B–Y
EXT SYNC
G/Y
AUDIO
REMOTE 1RS-232C
Y/C
IN
R/R–Y
B
A
IN OUT IN OUT IN OUT IN OUT IN OUT
DC OUT
REMOTE
EXT SYNC
RGB/COMPONENT
B/B–Y
INININ IN IN
MAJ-227
to OEV
to OEV
MAJ-227
IN
8V/0.8A
Notes
To Next Page
Loading...
