14
En
1 Press 2Y.
2 Press 12 to select [Y12 SEC] or [Y2
SEC], and press o.
3 Press the shutter button completely to take
the picture.
1 Press#(Flash pop-up) to open the flash.
2 Press 3#. Press 12 to select the flash mode, and press o.
3 Press the shutter button halfway.
When the flash is set to fire, the # mark lights.
4 Press the shutter button completely to take the picture.
To save battery power, the camera automatically enters sleep mode
and stops operating if not used for 3 minutes in shooting mode. Press
the shutter button or turn the zoom lever to reactivate the camera.
If the camera is not operated for 12 minutes after the camera enters
sleep mode, it automatically retracts the lens and turns off. To resume
operation, turn on the power again.
Y12 SEC The self-timer lamp lights for
approximately 10 seconds, then
starts blinking.
After blinking for approximately 2
seconds, the picture is taken.
Y2 SEC The self-timer lamp blinks for 2
seconds, then the picture is
taken.
Icon Flash Mode Description
AUTO
Auto flash The flash fires automatically in low light or backlight
condition.
!
Red-eye
reduction flash
Emits pre-flashes for red-eye reduction.
# Fill-in flash The flash fires regardless of the available light.
H
Red-eye fill-in
flash
The flash always fires after pre-flashes for red-eye
reduction are emitted.
#SLOW Slow flash The flash fires with slow speed.
$ Flash off The flash does not fire.
Self-Timer
Self-Timer Lamp
Flash Modes
Power Save Feature
d4355_e_basic_00_bookfile-E.book Page 14 Thursday, July 12, 2007 8:35 PM
To Next Page
Loading...
