Olympus STYLUS 1050 SW - Error message

Problem with selected image
Use photo retouch software, etc.
to edit the image
on a computer.
Error message
o When one of the messages below is
displayed on the monitor, check the
corrective action.
Printer problem
Refill the ink in the printer.
Printer problem
Load paper into the printer.
Problem with selected image
Use a computer to print.
Printer problem
Return to the status where the
printer can
be used.
Printer problem
Turn off the camera and printer.
check the printer for any
problems, and then turn the
power on again.
Connection problem
Connect the camera and
computer or printer correctly.
Printer problem
Remove the jammed paper.
Battery problem
Charge the battery.
Operation problem
Slide the lens barrier down to
take a picture.
Operation problem
Close the battery/card
compartment cover.
8Jv
JAMMED
SETIINGS
CHANGED"3
r±-I
NO PAPER
c::J
BATIERY
EMPTY
~
~
NOINK
THE LENS
BARRIER IS
CLOSED
Jr1
PRINT ERROR
®K
NO
CONNECTION
OJ
CARD·COVER
OPEN
[[]
CANNOT PRINP
"1 Before erasing important images, download them to
a computer.
"2 All data will be erased.
'3 This is displayed, for instance, when the printer's
paper tray has been removed. Do not operate
the printer while making the print settings on the
camera.
"4 This camera may be unable to print images taken by
other cameras.
Problem with selected image
Use photo retouch software,
etc. to view the image on a
computer. If the image still
cannot be viewed, the image file
is corrupted.
Internal memory/Card problem
Take pictures before viewing
them.
Card problem
• Use Ji\ ~ to select [CLEAN
CARD], and press the
@ button. Take out the card,
wipe the contact area (p"
64)
with a soft. dry cloth, and then
load the card again.
• Use
Ji\ W to select
[FORMAT], and press the
@ button. Next, use ~ W
to select [YES], and press the
@ button:
2
Card problem
• Replace the card.
• Erase unwanted images:
1
Internal memory problem
• Insert a card.
• Erase unwanted images:'
Card problem
Use a computer to cancel the
read-only setting.
Card problem
Insert a new card.
[[]
PICTURE
ERROR
rn
WRITE
PROTECT
rn
CARD FULL
NO PICTURE
rn
CARD ERROR
ill
MEMORY FULL
Internal memory problem
Use ~~ to select [MEMORY
FORMAT], and press the
@ button. Next, use Ji\ ~
L.- ~SET~.~~ I to select [YES]. and press the
@ button:
2
EN 59