Before
Use:
• Check the camera for foreign material
including dirt, dust or sand.
• Be sure to close the battery/card compartment
cover and connector cover firmly so that each
lock makes clicking sound.
• Do not open the battery/card compartment
cover and connector cover with wet hands,
while under water, or
in
a damp
or
dusty
environment (e.g. beach).
• Use the camera underwater with the lens
barrier in the down position.
To
turn the
camera
on
and off underwater, use the
POWER
button.
After
Use:
• Do not slide the lens barrier up until the
camera has been rinsed with water.
• Be sure to wipe off any excess water or debris
after using the camera under water.
•
After
the
camera
is
used
under
seawater,
immerse
the camera in a
bucket
containing
fresh
water
for
about
10
minutes
(with
the
battery/card
compartment
cover
and
connector
cover
firmly
closed).
After
that,
dry
the
camera
in
a
shade
with
good
ventilation.
• Water
drops
may
be
observed
on
the
inner
surface
of
the
battery/card
compartment
cover
or
connector
cover
after
you
open
each cover.
If
any
water
drops
are
found,
be
sure
to
wipe
them
off
before
using
the
camera.
Notes
after
use
• Foreign materials may be attached to the
periphery
of
the lens barrier from using the
camera
in
conditions with foreign materials
such as dirt, dust or sand, or when the lens
barrier is not moving smoothly. If you continue
to use the camera
in
such conditions, the lens
could become damaged or the lens barrier
could stick causing additional damage to the
camera.
To
avoid such damage, wash the
camera using the following method.
CD
Insert the battery and close the battery/
card compartment cover and connector
cover firmly so that each lock makes the
clicking sound.
® Fill a bucket with fresh water, immerse
the camera
in
the bucket with the lens
surface downward and shake the camera
thoroughly.
@ Rinse the front of the camera with running
water while the lens barrier is open.
Follow Steps
CD
to
@,
then check if the lens
barrier moves smoothly. If the lens barrier does
not move smoothly, rinse the lens barrier by
placing it directly under fast running water.
Storage
and
Maintenance
• Do not leave the camera in
an
environment at
high temperature (40°C (104°F) or more) or at
low temperature (-10°C (14°F) or less). Failure
to do so may break down water resistance.
• Do not use chemicals for cleaning, rust
prevention, anti-fogging, repairing, etc. Failure
to do so may break down water resistance.
• Do
not
leave
the
camera
in
water
for
a
long
time. Failure
to
do
so
will
cause damage
to
the
camera's
appearance
and/or
deteriorate
water
resistance.
• In
order
to
preserve
the
water
resistant
feature, as
with
any
underwater
housing,
it
is
recommended
that
the
waterproof
packing
(and seals) are replaced annually.
For
the
Olympus
distributors
or
service
stations
where
the
waterproof
packing
can
be replaced,
visit
Olympus
website
for
your
local
area.
EN
To Next Page
Loading...
