64
Compatible equipment
* All electrosurgical generators satisfying the interface
requirements can be connected to the HF cable. For non-
Olympus electrosurgical generators, refer to the below interface
requirements.
HF cable Interface requirements for electrosurgical generators
(non-Olympus)
A60001C Pin diameter: 2 × 4 mm (spring basket)
Pin spacing: 22 mm
Maximum rated voltage: 1000 V
p
Maximum crest factor: 2.0
A60002C Pin diameter: 2 mm (5 mm bushing)
Maximum rated voltage: 1000 V
p
Maximum crest factor: 2.0
A60003C Pin diameter: 2 × 4 mm (spring basket)
Pin spacing: 28.6 mm
Maximum rated voltage: 1000 V
p
Maximum crest factor: 2.0
To Next Page
Loading...