Need help?Do you have a question about the Omax JetMachining Center 2652 and is the answer not in the manual?
General| Model | JetMachining Center 2652 |
|---|---|
| Category | Cutter |
| Y-Axis Travel | 52 in (1, 321 mm) |
| Maximum Material Size | 52 in x 104 in (1, 321 mm x 2, 642 mm) |
| Controller | OMAX IntelliMAX Software |
| Power Requirements | 220V, 3 Phase, 60 Hz |
| Control System | OMAX Windows-based control |
To Next Page
