Need help?Do you have a question about the Omax JetMachining Center 80X and is the answer not in the manual?
General| Table Size | 94 in x 174 in (2, 388 mm x 4, 420 mm) |
|---|---|
| Pump Power | 30-100 hp (22-75 kW) |
| X-Axis Travel | 80 in (2, 032 mm) |
| Y-Axis Travel | 80 inches |
| Controller | OMAX IntelliMAX Software |
| Control System | OMAX IntelliMAX Software |
Outlines essential safety rules and procedures to follow while operating the OMAX.
Provides step-by-step instructions for starting, operating, and stopping the high-pressure pump.
Explains the function of OMAX Layout and Make software for part creation and machining.
Details regular and scheduled maintenance procedures for the OMAX high-pressure pump.
Provides solutions for common fault messages and operational problems with the pump unit.
To Next Page