Ombra 120v - Page 9

To Next Page

To Previous Page

4. Unscrew and remove the NEBULIZER TOP. Carefully place prescribed medication into NEBULIZER CUP. Reattach

the NEBULIZER TOP, making sure to line up the WHITE CYLINDER with the STEM of the NEBULIZER CUP and

gently hand tighten until a stop is detected. Correct assembly is shown in Figure 6. Ensure nebulizer is kept in an upright

position so medication does not spill.

FIGURE 6

FIGURE 7

6. Plug the Ombra* Table Top Compressor into an electrical outlet.

7. In a relaxed, comfortably seated position, pick the nebulizer up out of the CUP HOLDER. Switch on the compressor

and start your treatment.

8. When your treatment is complete or during a rest in your treatment, the nebulizer may be placed back in the CUP

HOLDER and the compressor switched off.

NOTE: The compressor should be unplugged when not in use.

5. Connect one end of the EZ Twist TUBING to the fitting on the bottom of the nebulizer and the other end to the AIR

OUTLET on the compressor. Ensure both ends are securely engaged. The nebulizer may then be placed in the CUP

HOLDER on the compressor until you are ready to start your treatment as shown in Figure 7.