Ombra 120v - Before You Begin

EN
6
10. Never drop or insert any object into any openings.
11. Ensure the compressor is unplugged prior to cleaning.
12. The Ombra* Table Top Compressor could cause interference with some types of electronic equipment. To reduce the
risk of interference, move it further away from the electrical equipment.
13. Use this compressor only for its intended use as described in this guide. Do not open or disassemble the Ombra* Table
Top Compressor. Refer all servicing to your Ombra* Authorized Distributor.
14. Do not use attachments not recommended by the manufacturer.
WARNING: Close supervision is necessary when this product is used by or near infants, children or anyone requiring
assistance to use the device. It contains parts that may present a choking or strangulation hazard. DO NOT LEAVE CHILDREN
UNATTENDED DURING TREATMENTS.
BEFORE YOU BEGIN
For compressor part descriptions see Figure 1.
Ensure you have thoroughly read and understood all of the instructions for use for your Ombra* Table Top Compressor
before you begin your treatment. Keep your OWNER’S MANUAL in a safe place for future reference. To download an
electronic copy of this OWNER’S MANUAL, visit www.aeroeclipse.com
1. Place the compressor on a clean, flat surface or table top. Ensure there is nothing blocking the AIR VENTS on either
side of the compressor. Verify that the ON/OFF SWITCH is in the ‘Off’ position.
OFF
ON
FIGURE 3
2. Read and understand the instructions included with your reusable AEROECLIPSE * XL Breath Actuated Nebulizer
(BAN).
3. Assemble the nebulizer and ensure you have installed the mouthpiece with the EXHALATION VALVE pointing down.
(Fig. 2). If you are using your reusable AEROECLIPSE * XL BAN with a ComfortSeal* Mask (Fig. 4), remove the
mouthpiece and insert the elbow adapter directly into the nebulizer cup as shown in Figure 5.
Exhalation Valve
Elbow Adapter
FIGURE 4
FIGURE 5