9
Leveling
Location
How to Install
Install the refrigerator in a convenient location away from extreme heat and cold. Allow at least 6cm
clearance between the refrigerator and side wall so that the door may open for a fully usable interior
and the refrigerator may have good air circulation. The refrigerator is not designed for recessed
installation.
Select a strong and level floor.
Keep 6cm of space between the refrigerator
and the walls.
Level the refrigerator so that it rests solidly on the floor without rocking. There are two leveling feet at
each front corner. Turn to the left to raise a corner, to the right to lower it. Use shims under the rear
corners, if necessary.
If you want the refrigerator door to close naturally, adjust the leveling feet so that the front of the
refrigerator is raised by 5mm.
If you want the refrigerator to remain motionless when open, adjust the leveling feet so that all
four corners are leveled with each other.
NOTE: All packing materials used to ensure safety during transport should be removed. You
must remove the transport safety packing and wipe off any possible adhesive tape
residues with a petroleum-based cleaner or similar solvent.
To Next Page
Loading...
Need help?
General
