EasyManua.ls Logo

Omega 7142 - Attaching Lace

Omega 7142
59 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- Turn stitch length dial to the desired length.
- Turn the stitch selector to straight stitch, center needle
position.
- Fold in the edge of the fabric (approximately 6 mm 1/4").
- Place the lace under the folded edge of the fabric allowing
it to under lap the fabric slightly as required by the pattern
of the lace.
- Sew on the edge of the fabric fold.
- You can add a decorative touch by using the satin stitch to
sew the lace.
Pose de la dentelle
- Régler le bouton de longueur de point selon la longueur
désirée.
- Placer le sélecteur de point à la couture droite, position
d'aiguille au centre.
- Plier le bord non fini de l'ouvrage environ 6mm (1/4").
- Placer la dentelle sous le bord replié de façon à ce que le
dessus chevauche légèrement le dessous tout en suivant
le patron de la dentelle.
- Coudre près du bord replié.
- Vous pouvez ajouter une touche de fantaisie en utilisant un
point satin à la place du point droit.
Cómo pegar encajes
- Gire el disco selector del largo de puntada al largo deseado.
- Gire el selector a costura recta, posición central de la aguja.
- Pliegue el borde de la tela (aproximadamente 6 mm, 1/4").
- Coloque el encaje debajo del borde plegado de la tela
dejando que sobresalga ligeramente la tela, según requiera
el dibujo del encaje.
- Cosa el borde de la tela doblada.
- Puede añadir un toque decorativo usando el punto de raso
para coser el encaje.
Attaching lace
40
A
0
1
2
3
4
S
5
0
1
2
3
4

Table of Contents

Related product manuals