(12) When it is ‘ON TIME’, heater starts
heating using the confirmed power, the
corresponding power indicator light is on.
User can change the power by choosing
a new power. When it is ‘OFF TIME’,
heater stops heating.
(13) User has to press the ‘SET’ button after
selecting power; otherwise the previously
set power cannot be overridden.
(14) In Manual and timer mode, heater can be
switched off by pressing the ‘ON/OFF’
button.
(15) To select the anti-frost function, turn the
knob to ‘snowflake’ symbol position.
When temperature falls to or below 5ºC,
heater starts working and the ‘Power I’
and ‘Power II’ indicating lights are on.
(16) Once ‘ON’ and ‘OFF’ times are set,
heater will stat and stop daily at the set
times unless the ‘ON/OFF’ switch at the
bottom of the control end cap is switched
off.
(17) When the power is resumed, the ‘SET
ON/OFF’ times are still operational but
not the clock time. User has to re-set
the clock time to have the timer function
operates.
In manual mode, press the ‘SET’ button for a few
seconds and ‘SET ON/OFF’ times are discarded.
CLEANING
(1) Before cleaning, turn off the heater, unplug
the power cord and allow the heater to
cool down.
(2) Do not immerse the heater, power cord
and plug in water or other liquid. Do not
pour water or other liquid over the heater.
(3) Use a vacuum cleaner to remove dust and
lint on the metal grid of the heater.
(4) Wipe the heater with a dry cloth to remove
dust and a damp cloth (not wet) to clean
off stains.
(5) Do not use detergents, abrasive cleaning
powder or polish of any kind on the body
of the heater, as these can damage the
heater.
STORAGE
Store the heater in a cool dry place. To
prevent dust and dirt getting in the heater use
the old packaging to repack the unit.
If the heater is not used regularly or if it is
stored uncovered, the heater may produce
small amounts of smoke and/or smell upon
first use. This is normal, it is due to the
accumulation of humidity and dust on the
heating element.
TROUBLE SHOOTING
IF YOUR HEATER IS NOT WORKING THEN
CHECK THE FOLLOWING:
HEATER NOT WARM:
(1) Check if the heater is turned on or not.
(2) Check the Thermostat Control Knob is on
maximum position or not.
(3) Check if any objects are covering the
heater.
HEATER NOT OPERATING:
(1) Check if the power cord is plugged into an
electrical outlet or not.
(2) Check if the electrical supply in the main
house or the main fuse is working or not.
(3) Make sure the power switch is on.
(4) Check the Thermostat Control Knob is on
maximum position.
If after you have carried out the above checks
the heater is still not working then return it
to your nearest Authorised Eurolux Service
Agent.
To Next Page
Loading...