Witheachwashcycle.
For pro grammes with pre-wash only.
(Follow the )User Manual
Electric indicator on control pane l (if provided).
Check the rinse aid level
Load the baskets
Select a programme
Turn on the water tap and press the . T he machine will start working
after about 10 seconds.
Start/Pause Button
Running the dishwasher
Switch off the appliance
Turn off the water tap,
unload the baskets
Fill the detergent dispenser
Warning: wait a few minutes (about 15 minutes) before unload ing the dishwasher to avoid handl ing
the dishes and utensils while they are still hot an d more susceptible to break.
They will also dry better.Unload t he appliance, starting fro m the lower basket.
Changing the programme
Add forgotten dishes in the
dishwasher.
Scrape off any large amount of leftover food. Soften r emnants of burnt foo d in pa ns,
then l oad the baskets. Refer to the dishwasher loading instructions.
Close the door,press the Programme Button until the selected programme lights up.
( See the section entitled Operation instructi on )āā
When the working cycle has finished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the On/Off Button.
If the appliance is switched
off during a wash cycle.
Op en t he do or car ef ul ly.
Hot s team may esc ape
when thedoor is opened
If the appliance is switched off during a wash cycle, when switched
on agai n, plea se re-select th e washing cycle and operate the dishwasher
according to the original Power-on state.
Switch on the appliance Press the On/Off button to switch on the applianc e, Op en the door.
For detailed operating method read the corresponding content on t he instructio n manual.
1. A running cycle can only be modified if it has been running for a short time. Otherwise the deterg ent
m ay have alre ady be en released and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2. Press the Start/Pa use bu tton, press the program button for more than three seconds,the
m achine will be in standby state, then you can change the program to the desired cycle setting
1.Press the Start/Paus e But ton to stop the washing.
2.Open the door a little .
3.After the spra y arm s stop w orking, you c an open the door
c ompletely.
4.Add forgotten dishes.
5.Close the door.
6.Press the St a rt/Pau s e Button, the dishwasher will run
after 10 seconds.
To Next Page
Loading...
