Omega Carlink OMEGA-CARLINK - Connect Device - ANALOG; BLACK Ground Wire; GREEN Auxiliary Output Wire; YELLOW Auxiliary Output Wire

4
This system can be installed as a stand-alone system or to control ana-
log activation inputs on an older host system that does not support the iDatalink
protocol for CarLink. To be connected this way, you will need to cut off the
GREEN 4-pin data connector.
NOTE: As an analog system, it cannot report alarm violations but it will still give 2-way conr-
mations for all control functions.
BLACK Ground wire (required):
This provides chassis ground to the device. It should be connected
directly to the metal structure of the vehicle. Strip the end of the wire and crimp
on the supplied ring terminal. Route this wire to a solid grounding point, like an
existing bolt in the vehicle and securely ground the wire.
GREEN Auxiliary output wire (optional):
 Thisisanegativepulse250mAoutput(addarelayifnecessary)con-
gurableformanyapplications.Duringtheinstalltestontheomegacarlink.com
website,youcancongurethisoutputfora1,3,or10secondpulseANDyou
can assign it to any one of the 6 function icons in the phone app.
YELLOW Auxiliary output wire (optional):
 Thisisanegativepulse250mAoutput(addarelayifnecessary)con-
gurableformanyapplications.Duringtheinstalltestontheomegacarlink.com
website,youcancongurethisoutputfora1,3,or10secondpulseANDyou
can assign it to any one of the 6 function icons in the phone app.
BROWN Auxiliary output wire (optional):
Thisisanegativepulse250mAoutput(addarelayifnecessary)con-
gurableformanyapplications.Duringtheinstalltestontheomegacarlink.com
website,youcancongurethisoutputfora1,3,or10secondpulseANDyou
can assign it to any one of the 6 function icons in the phone app.
RED Constant power wire (required):
This is the power supply wire to the device. It must be connected to a
FUSED constant +12V source. This can be found in the ignition switch harness,
a fuseblock, or at the vehicle’s battery. Be certain that this wire has +12V under
all circumstances and when the ignition key is in the ON and OFF positions.
BLUE: NOT USED
ORANGE: NOT USED
WHITE: NOT USED
Step 3b: Connect the device - ANALOG