Omega DP41-S-230 - SECTION 8 METHODS FOR SCALING THE METER TO DISPLAY IN ENGINEERING UNITS; SECTION 16 EXTERNAL CONTROL LINES; SECTION 17 DISPLAY MESSAGES AND TROUBLESHOOTING GUIDE; SECTION 18 SPECIFICATIONS

16.11 Print Command and/or Reset of Alarms (PIN 11) ................16-2
16.12 Nonstandard RX (PIN 12) and Nonstandard TX (PIN 13) ...16-2
16.13 PUSH TO CAL (PIN 14).......................................................16-3
16.14 +V EXT (PIN 15)..................................................................16-3
16.15 SP1 (PIN 16)........................................................................16-3
16.16 SP2 (PIN 17)........................................................................16-3
16.17 AL1 (PIN 18)........................................................................16-3
16.18 AL2 (PIN 19)........................................................................16-3
16.19 RTN EXT (PIN 20) ...............................................................16-3
SECTION 17 DISPLAY MESSAGES AND TROUBLESHOOTING GUIDE
17.1 Error Mode Message ...........................................................17-1
17.1.1 Flashing “999999” (Numerical Overflow).............................17-1
17.1.2 Flashing “ERR O1” (Offset Overflow) ..................................17-1
17.1.3 Flashing “ERR O2” (Setpoint Overflow)...............................17-1
17.1.4 “NOSTOR” & “STORED
(Programming Entries In EEPROM)....................................17-1
17.1.5 Flashing “+OVLD” (Positive Input Overload) .......................17-1
17.1.6 Flashing “+OPEN” (Open Sensor Indication) ......................17-1
17.1.7 Flashing “-OPEN” (Open Sensor Indication) .......................17-2
17.1.8 Flashing “I OVSC” (Input Overscale)...................................17-2
17.1.9 Flashing “R OVSC” (Reading Overscale)............................17-2
17.1.10 Flashing “CB OVF” (Count By Overflow).............................17-2
17.1.11 Flashing “UOM.OVF” (Unit Of Measure Overflow) ..............17-2
17.2 Troubleshooting Guide ........................................................17-2
SECTION 18 SPECIFICATIONS
18.1 Current Input........................................................................18-1
18.2 Voltage Input........................................................................18-1
18.3 Potentiometer Input .............................................................18-1
18.4 General................................................................................18-1
SECTION 19 FACTORY PRESET VALUES .............................................19-1
SECTION 20 RECORD YOUR SETUP VALUES......................................20-1
Table of Contents
iv