6. Troubleshooting
LIGHTS DESCRIPTION
- The dishwasher is not able to fill or discharge
the tank.
- Temperature sensor disconnected (on some
models only).
- Alternate washing system malfunction (on some
models only).
- Water level at limit (on some models only).
+ continuous beep
- Anti-flooding system or safety level switch
tripped.
In some cases, the alarm signal may indicate a temporary problem, so
before contacting the after-sales service, proceed as follows.
• Open and close the door, or switch the dishwasher off and back on,
and if necessary reprogram it.
If the problem persists, contact the after-sales service.
In case of a malfunction, the dishwasher will warn the user by flashing
the
ON/OFF (2)
and
START/PAUSE (4)
lights, in some cases combined
with a continuous beep.
TECHNICAL DATA
Width
597
÷
599 mm
Depth measured flush with the
outer edge of the control panel
Free standing: 600 mm
Semi-integrated: 570 mm
Height
Free standing from 850 mm to 870 mm
Semi-integrated from 820 mm to 870 mm
Capacity
12 Standard place settings
Water supply pressure
min. 0,05 - max. 0,9 MPa (min. 0.5 – max. 9 bar)
Electrical characteristics
See rating plate
31
User instructions
To Next Page
Loading...
