The data record key: The data record is divided into real time recording and scheduled recording on
page 13. Set up the recording interval time from instructions on page 16.
To start recording in real
time press the button.
interval set quantity of data
Data logging starts at the
points appears in the third
display.
To stop recording press the
button.
Review logged data pen
instructions on page 9.
When in the scheduled
record mode the following
electricity settings are
available.
Mode to save electricity is under order setting record: Need to set up ( INTV) interval time ≥ 10 seconds.
Can increase the service time of order setting record.
press power key once＞Enter mode 1 of save electricity
，
，，
，
symbol will glimmer, MCU will enter
the sleep state, will start MCU when the measurement recorded. Press power key again finishes mode
of save electricity 1.
press power key for 2 seconds
＞
Enter mode 2 of save electricity
，
，，
，
symbol and REC will
glimmer，
，，
，MCU will enter the sleep state
and close the peripheral drive circuit, will start MCU and drive
circuit when wanting to measurement record. If unable to finish the function of order setting record
under mode of save electricity 2, press power key 2 seconds to finish order set
ting record function.
H
H
8
To Next Page
Loading...
