Omega JCUBE500 - Switch Operation Modes; Assembly Steps for Use

SWITCH OPERATION MODE & ASSEMBLY FOR USE
SWITCH OPERATION MODE:
ON: Push I (or on)
OFF: Push REV momentarily
REVERSE: Push and hold down REV
ASSEMBLY FOR USE:
1. Unit is stored.
2. Remove the top front container.
3a. Remove adjustable end cap.
3b. Set adjustable end cap to the side.
4a. Remove the juice cone.
4b. Set juice cone to the side.
5a. Remove the auger.
5b. Set the auger to the side.
6. With the locking clip in the open
position, remove the drum.
7. Place the drum in an upright position.
(feed chute will be facing up).
Place the drum onto the locking clip.
8. Close the locking clip by adjusting
clockwise to close and put the hopper
on the feed chute.
1 2
3a
4a
5a
6
7
3b
4b
5b
8
9