Witheachwashcycle.
Compartment
For programmes with pre-wash only.
(Follow the us er instructions!)
Electric indicator on control panel (if pro vided).
Check the rinse aid level
Load the baskets
Select a p rogramme
Close the door, turn on the water tap and press the Start/Paus e button. The machine will start working
after about 10 seconds.
Running the dishwasher
Switch off the appliance
Turn off the water tap,
unload the baskets
Fill the detergent dispenser
Warning: wait a few minutes (about 15 minutes) before unload ing the dishwasher to avoid handling
the dishes and utensils while they are still hot and more susceptible to break.
They will a lso dry better.Unload t he appliance, starting from the lower basket.
Changing the programm e
Add forgotten dishes in the
dishwasher .
Scrape off any large amount of leftover food. Soften remnants of burnt food in pans,
then l oad the baskets. Refer to the dishwasher loading instructions.
Press the Programme button until the selected programme lights up.
( See the section entitled Operationg instruc tion )“”
When the working cycle has finished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the Power button.
If the appliance is switched
off during a wash cycle.
Op en t he door caref ul l y.
Hot st eam may esc ape
when thedoor isopened!
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate the dishwasher
according to the original Power-on state ).
Switch on the appliance Press the Power switch button to switch on the appliance, Op en the door.
1.Open the do o r a little to st o p the dishwasher.
2.After the spray arms stop working, you can open the door completely.
3.Add the forgotten dishes.
4.Close the door, the dishwasher will start running again after 10 seconds.
For detailed operating method read the corresponding conte nt on t he instructio n manual.
1. A running cycle can only be modified if it has been running for a short time. Otherwise the deterg ent
m ay have already been released and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2. Press the Start/Pause button ,than press the program button more than 3 seconds to cancel the
running programme.
3. Select a new programme.
4. Restart the dishwasher.
To Next Page
Loading...
