Hardware
2
2-4
2.3.2 Laser Sighting Accessory Operation
The laser sight accessory screws onto the front of the sensor head. This accessory
is only used for alignment of the sensor head to the target area. After the
alignment process, the accessory has to be removed from the front of the sensor
head before temperature measurement.
The laser sight accessory is powered from a small compact battery pack
(included with the accessory). Connect the battery pack to the accessory using
the cable provided. Aim at the target, and turn on the battery power using the
slide switch on the battery pack. Adjust the sensor head position so that the
laser beam points to the center of the target area. Turn off the battery pack,
and remove the laser sighting accessory from the sensor head. See Fig. 2-5 for
reference.
You may receive harmful laser radiation exposure if you do not adhere to the
warnings listed below:
• Use of controls or adjustments or performance of procedures other
than those specified here may result in hazardous radiation exposure.
• Do not look at the laser beam coming out of the lens or view directly
with optical instruments - eye damage can result.
• Use extreme caution when operation the laser sight accessory
• Never point the laser accessory at a person
• Keep out of the reach of all children
Do not attempt to open the laser sight accessory. There are no user serviceable
parts inside.
CAUTION:
WARNING:
To Next Page
Loading...
