Other Features
If the unit breaks off unexpectedly due to power outage, it will automatically restart with the previous
function settings when the power resumes.
AUTO-RESTART
After the unit has stopped, do not restart in the first 3 minutes. This is to
protect the unit. Operation will automatically resume after 3 minutes.
WAIT 3 MINUTES BEFORE RESUMING OPERATION
The louver can be adjusted automatically. Adjust the
air flow direction automatically (NOTE: The louver on some models
can be only adjusted manually):
-When the power is ON, the louver opens fully.
-Press the SWING button on the panel or remote
controller to initiate the Auto swing feature. The
louver willl swing up and down automatically.
-Please do not adjust the louver manually.
AIR FLOW DIRECTION ADJUSTMENT
-During dehumidifying modes, remove the upper drain
plug from the back of the unit and install the drain
connector (5/8" universal female mender) with a 3/4"
hose (locally purchased). For models without a drain
connector, just attach the drain hose to the hole. Place
the open end of the hose directly over the drain area in
your basement floor.
Water Drainage
NOTE: This feature can be activated from the remote controller ONLY. The remote
controller serves as a remote thermostat allowing for precise temperature control
at its location. To activate the "I SENSE/Temp Sensing" feature, point the remote
controller towards the unit and press the "I SENSE/Temp Sensing" button. The
remote controller displays the actual temperature at its location. The remote
controller will send this signal to the air conditioner at 3-minute intervals until the
"I SENSE/Temp Sensing" button is pressed again. If the unit does not receive the
"I SENSE/Temp Sensing" signal within a 7-minute interval, the unit will beep to
indicate the end of the "I SENSE/Temp Sensing" mode.
6&$/(
I SENSE/TEMP SENSING Feature (Optional)
19
OPERATION
To Next Page
Loading...