Used to initiate the Wireless function.
For the first time to use Wireless
function, press and hold the swing
button for 3 seconds to initiate the
Wireless connection mode. The LED
DISPLAY shows 'AP' to indicate you
can set Wireless connection. If
connection(router) is successful within
8 minutes, the unit will exit Wireless
connection mode automatically and
the Wireless indicator illuminates.
If connection is failure within 8 minutes,
the unit exits Wireless connection mode
automatically. After Wireless connection
is successful, you can press and hold
SWING and DOWN (-) buttons at the
same time for 3 seconds to turn off
Wireless function and the LED DISPLAY
shows 'OF' for 3 seconds, press SWING
and UP(+) buttons at the same time to
turn on Wireless function and the LED
DISPLAY shows 'On' for 3 seconds.
NOTE: When you restart the Wireless
function, it may take a period of time to
connect to the network automatically.
Swing Button (Optional)
Used to initiate the auto-swing
feature(for models with the auto
swing feature only). When the
unit is ON, pressing the SWING
button can stop the louver at the
desired angle.
Timer Button
Used to initiate the AUTO ON
start time and AUTO OFF stop
time program, in conjuction with
the + & - buttons. The timer ON/OFF
indicator light illuminates under
the timer ON/OFF settings.
Mode Button
Selects the appropriate operating
mode. When pressing the button,
a mode is selected in a sequence
that goes from AUTO, COOL, DRY,
FAN, and HEAT (for models without
cooling only).The mode indicator light
illuminates under the different mode
settings.
16
Sleep/Eco Button
Used to initiate the SLEEP/ECO
function.
Up (+) and Down (-) Buttons
Used to adjust (increasing/decreasing)
temperature settings in 1°C/1°F
increments in a range of 17°C/62°F to
30°C/86°F or the TIMER setting in a
range of 0~24 hrs.
NOTE: The control is capable
of displaying temperature in
degrees Fahrenheit or degrees
Celsius. To convert from one
to the other, press and hold
the Up and Down buttons at
the same time for 3 seconds.
Fan/Ion Button
Power Button
Power switch on/off.
Fan/Constant fan(On some models) button
Control the fan speed. Press to select the fan
speed in four steps-LOW, MED, HIGH and
AUTO. The fan speed indicator light illuminates
under different fan settings. When select
AUTO fan speed, all the fan indicator lights
turn dark. On some models, when select
AUTO fan speed, all the fan indicator lights
illuminate.
NOTE: In cooling or Dry mode, press the
button for 3 seconds to turn on or off the
constant fan function. When the function is
turned on, the constant fan light will illuminate,
identifying the fan continuous run for cooling.
When the function is turned off, the constant
fan light will go out, identifying the fan cycle
run with compressor stop.
OPERATION
To Next Page
Loading...