zipldr_setup&operations
www.OmniTurn.com support@OmniTurn.com (541) 332-7004 (541)-332-1018 fax
Fast... Precise... Aff ordable...
Zip Loader Setup & Operations
OmniTurn
Page 1 of 44
Zip-Loader Installation, Operations,
and Technical Documentation for GT-75
(Including 1/16” Knife and Hopper Options)
Description
The OmniTurn Zip Loader is a multi-mode auto-loader that works as a short bar-loader or
as a part-loader.
Bars or parts are lifted one at a time from the tray (or hopper) onto a guide-trough, then
fed through the spindle liner into the collet.
Parts can be qualified from the face or from the rear, for overall length.
When the part is located, the collet is closed and the part is machined.
After machining, the part is ejected and the cycle begins again.
This document includes the hopper option and the 1/16” knife option.
The 1/16” knife is designed for loading parts or bars as small as 0.070” diameter.
The parts hopper option is designed to increase the number of parts that can be loaded
with the ZipLoader. The standard hopper accommodates parts from 1/2” diameter
to about 1/8”. For hopper operation with parts as small as 0.085” diameter some
modification would be necessary.
Dec 2019
To Next Page
Need help?
General