Omron CS1W-ETN11 User Manual

211
Results Storage Area Response Codes Section 10-7
0043 EDESTADDRREQ Destination address required (desti-
nation address not specified)
Close the local socket and try reopening it.
0044 ENOPROTOOPT Protocol not available (unsupported
option specified)
0045 ECONNABORTED Software caused connection abort
(another task closed socket)
0046 EINPROGRESS Operation now in progress (non-
block connection ended during pro-
cessing)
0047 ENOTSOCK Socket operation on non-socket
0048 EOPNOTSUPP Operation not supported on socket
0049 EADDRINUSE Address already in use (UDP or
TCP open request sent for port
already in use)
Check the port number.
TCP ports can remain unusable for 1 min after
closing.
004A ECONNREFUSED Connection refused (TCP socket
(active open) processing refused by
remote node)
Passively open a remote TCP socket, checking
the remote IP address and remote TCP port
number.
004B ECONNRESET Connection reset by peer (TCP
socket closed by remote node)
Close the local socket and try reconnecting.
004C EADDRNOTAVAIL Can’t assign requested address
(mistake in remote IP address)
Check the setting of the remote IP address and
try reconnecting.
004D EAFNOSUPPORT Address family not supported by
protocol family
Close the local socket and try reopening it.
004E ENETUNREACH Network is unreachable Set the path to the remote node in the IP router
table.
004F EHOSTDOWN Host is down Check the remote host and communications
path.
0050 EWOULDBLOCK Operation would block Close the local socket and try reopening it.
0051 EHOSTUNREACH No route to host The specified node does not exist on the desig-
nated IP network segment. Check the commu-
nications path.
0053 ETIMEDOUT Connection timed out (TCP timed
out)
Check the remote host and communications
path.
0063 ESELABORT Used for internal Ethernet Unit pro-
cessing
Close the local socket and try reopening it.
0066 (None) Internal memory cannot be allocated
for processing; the service cannot
be provided.
Traffic is too high at the Ethernet Unit. Correct
the user application to reduce traffic at the
Ethernet Unit.
0080 (None) Timed out for passive TCP open
request
Either the remote node is not executing an
active TCP open or there is a block on the net-
work.
0081 (None) Closed by close command during
socket servicing
No action is necessarily called for.
0082 (None) Connection with remote node not
achieved for passive TCP open
request
The remote IP address and TCP port number
settings differ from those of the remote socket
(active side).
Response
code
UNIX error
message
Description Probable remedy

Omron CS1W-ETN11 Specifications

General

Brand	Omron
Model	CS1W-ETN11
Category	Controller
Language	English