Network Software
Integrated software to simplify network configuration and start-up.
Easy configuration for even the most complex of settings.
CX-One covers all of the automation network setting and startup
procedures. The setting and configuration can be made from
any PLC in the network through ‘One Connection’. The networks
covered include all of the common networks - Ethernet and
Integrates together OMRON Automation
Network Software
Controller Link peer-peer networks, Mechatrolink II
motion network, Profibus & DeviceNet fieldbuses and
CompoWay/F & Modbus serial networks.
Graphically configure and start-up any network from CX-Integrator
• The current parameter settings of the
Communications Units can be brought up
in a Window from a PLC in the FA network.
• The online verification function displays
differences between the actual Units
and settings.
• Each parameter setting window displays the
present setting. It is not necessary to refer to
the manual when editing, because the CPS
file’s information identifies each parameter
and shows the allowed setting range.
DeviceNet/Profibus
Ethernet
Controller Link
CompoWay/F MECHATROLINK-II
1
To Next Page
Loading...
