Omron MicroAir NE-U22V - How to Fill the Medication Bottle

How to Fill the Medication Bottle
12
How to Fill the Medication Bottle Correct Use of the Unit
Have you removed Mask Adapter and the supplied Mouthpiece?
(For how to assemble the Main Unit, refer to Page 8)
1 Remove Medication Bottle
from the Main Unit.
3 Fill Medication Bottle.
Be careful to prevent the Mesh Cap from closing
as shown in the Figure.
– The maximum capacity of Medication Bottle is 7 ml.
4 Close the mesh cap.
– Be sure to check that the Mesh Cap
is engaged. If it is not engaged,
medication will leak.
Click
Press gray tabs on
both side of Medication
Bottle at the same
time lift upwards.
Check that the
Mesh Cap is closed.
Do not open the
bottle cap.
Lift up the mesh
cap while pressing
your thumb hard
on the brim.
2 Open the Mesh Cap.
Hold the medication bottle as if covering
it with your hand.