OMT-Veyhl OV1013 - User Manual

Questions and Answers

J
Julie MillerAug 3, 2025
What to do if OMT-Veyhl OV1013 table does not move?
- C
  Cynthia West DDSAug 4, 2025
  If your OMT-Veyhl Indoor Furnishing table does not move, it could be due to several reasons. First, ensure that the power cord is properly plugged in or check the connection on the control box. Also, verify the motor cable plug connections to the control box and handswitch. If the table is overloaded, reduce the weight on the desktop. Note that the control is activated automatically after approximately 9 minutes. If none of these steps work, it might be a defective drive or control box, in which case you should contact customer service. Alternatively, the handset might be defective and needs replacement.
C
Cassandra GreenAug 11, 2025
Why OMT-Veyhl Indoor Furnishing table moves on one side only briefly and then stops?
- K
  kennethcarterAug 11, 2025
  If your OMT-Veyhl Indoor Furnishing table moves on one side only briefly and then stops, check the motor cable plug connections to the control box and then reset the control box. If the issue persists, the drive may be defective, and you should contact customer service.
C
Carol MorganAug 18, 2025
What to do if OMT-Veyhl Indoor Furnishing table moves down at a slow rate?
- J
  Jasmine PorterAug 19, 2025
  If your OMT-Veyhl Indoor Furnishing table moves down at a slow rate, the control box may need a reset. Reset the control box to resolve this issue.
A
Amy DunnAug 26, 2025
Why OMT-Veyhl OV1013 table moves at a slow rate during operation?
- D
  Darrell McdanielAug 26, 2025
  If your OMT-Veyhl Indoor Furnishing table moves at a slow rate during operation, it is likely that the maximum lifting capacity has been exceeded. Reduce the weight on the table to ensure it operates at the correct speed.