EVBUM2565/D
www.onsemi.com
2
EVALUATION AND DEVELOPMENT BOARD
Evaluation and Development Board Setup
This section is an overview of how to configure the
Evaluation and Development Board. Details of the
development board configuration are discussed later in this
manual.
Figure 1 represents an overview of the board setup.
Figure 1. Evaluation and Development Board Setup
RSL10
Evaluation and
Development
Board
Micro USB Cable
If you want to use an external J−Link debugger instead of
the onboard one, connect the debugger to connector P2 on
the SiP board, as shown in Figure 2. Notice that for this
setup, you also need a power supply.
Figure 2. Evaluation and Development Board Setup with External J−Link Debugger
Micro USB Cable
J−Link
Debugger
10/9 Pin Connector
RSL10 Evaluation and
Development Board
P2 or JTAG
Port
Power Supply
Evaluation and Development Board Design
The following sections detail the various sub-circuits of
the RSL10 SIP Evaluation and Development Board. The
block diagram in Figure 3 shows the locations of the various
circuit sections. Figure 5 and Figure 6 provide
3-dimensional illustrations of the SiP board.
To Next Page
Loading...
