1. Remove bench from the box.
2A. On the KB8802, place bench cushion-side
down on flat surface. Remove legs from
underneath the bench.
2B. On the KB8902, place the bench down on a
flat surface. Lift lid and remove legs. Once legs
are removed, place bench cushion-side down on
flat surface.
3. Remove nut and washer from one of the legs.
take leg and insert the threaded stud through the
corner bracket with the leg on the outside.
4. Replace washer first, then hand-tighten the nut
on the threaded stud.
5. Repeat steps 2 and 3 for remaining legs.
6. Fully tighten nuts with an adjustable wrench.
Read instructions below for the KB8902 only
The bench included with the KB8902 has a flip-top
seat with a storage compartment. The lid support
bracket tension was preset at the factory for shipping
conditions. To prevent the lid from accidentally
closing, adjust the tension on the support brackets
evenly on both sides until the lid remains half open.
Piano Benches
Flip Top / Non-Flip Top
KB8802 / KB8902
©2019 The Music People On-Stage.com
STANDS
Congratulations! You have purchased a professional, durable piano/keyboard
bench from On-Stage Stands. We sincerely hope you enjoy your new piano/keyboard
bench. With proper care, this bench will last you for years to come.
To Next Page
Need help?
General
