31
TROUBLESHOOTING
PROBLEM: LED (red light) does not blink when you
press a key.
SOLUTION: Replace batteries with two new AAA
alkaline batteries.
PROBLEM: LED blinks when you press a key, but
home entertainment device does not
respond.
SOLUTION: Make sure the remote control is aimed at
your home entertainment device and is
not farther than 15 feet away.
PROBLEM: The unit does not control home enter-
tainment devices or commands are not
working properly.
SOLUTION: Try all listed codes for the device brands
being set up. Make sure they can be
operated with an infrared remote control.
PROBLEM: Changing channels does not work
properly.
SOLUTION: If the original remote control required
pressing ENTER to change channels,
then press ENTER on the remote control
after entering the channel number.
PROBLEM: Tried Searching For Your Code method
and still could not find a working code.
SOLUTION: Clear the device key as follows: Press and
hold SET until the LED (red light) blinks
twice, then release.Next enter 9 - 9 - 2.
Then press the device key to be cleared
twice. Now repeat the Searching For Your
Code method on page 10.
PROBLEM: CH▲ and CH▼ do not work for your
RCA TV.
SOLUTION: Due to RCA design (1983-1987), only the
original remote control will operate these
functions.
PROBLEM: No remote control of volume.
SOLUTION: See Changing Volume Lock on page 16 to
lock/unlock volume.
PROBLEM: If the above does not work.
SOLUTION: Please contact us in any of the
following ways:
• Please visit : www.oneforall.com
• If the above website is not able to
provide you with the information you
need, please email us at
ofasupport@ueic.com
• Customer Support : (330) 405-8612
To Next Page
Loading...
