One for All URC-7140 - Macro Function Programming; Creating a Command Sequence Macro; Resetting a Macro Key

Press the key to which
the function will be
assigned (e.g. red key).
Macro
4
7
8
9
Press and hold magic for 3 seconds --> The blue LED will blink twice and then switch off.
Congratulations! You have successfully programmed a macro on the “red” key.
NOW, when you press the red key: 1st: dvd will STOP, 2nd: dvd switches OFF,
3rd: tv switches OFF. The remote will do this in every device mode whenever you
press the red key.
DVDDVD
OFF
Command 1: dvd STOP
Command 2: dvd OFF
Command 3: tv OFF
STOP
& OFF
Press the red key
Y
ou can program your ONE FOR ALL to issue a sequence of commands at the press of one single key. Any sequence of commands you regularly use can be reduced to one key press for
y
our convenience.
F
or example, you may want to create the following macro:
1
st command: dvd --> STOP
2nd command: dvd --> OFF
3
rd command: tv --> OFF
To set up the Macro mentioned above on the e.g. “Red” key on your ONE FOR ALL:
1
2
P
ress and hold magic for 3 seconds until a mode indicator (Blue LED) stays lit.
P
ress 9 9 5.
-
-> The blue LED will blink twice.
3
4
5
6
Press the STOP key
C
omman
d 1
C
omman
d 2
C
omman
d 3
How to reset the macro key to obtain its original function?
1) Press and hold magic for 3 seconds until a mode indicator (Blue LED)
stays lit.
2) Press 9 9 5.
3) Press the corresponding macro key (e.g. the red key).
4) Press and hold magic key for 3 sec. --> The blue LED will blink twice.
Press the POWER key
x2
3 sec.
< select >
3 sec.
Press the POWER key
Select the
corresponding
device e.g. DVD
< select >
S
elect the
c
orresponding
d
evice e.g.TV