WWW .ONEFORA LL.COM 3
Learning feature
The KAMELEON 8 comes equipped with the unique “learning feature”, which
m
eans that you can copy almost any function (max. ± 50) from your original
(
working) remote control onto your new KAMELEON 8 (See “Learning Feature”
on page 15). This comes in handy, when after having setup your KAMELEON 8
you may find that some functions from your original remote are missing on your
KAMELEON 8 key pad.
Macros (sequence of commands)
Your KAMELEON 8 comes with an easy-to-use Macro feature, allowing you to
send several commands with the press of a single key (for example turning a few
d
evices on or off).
Y
ou can use for example the custom keys (I, II, III, IV) for this feature. Once
you programmed a macro on one of these keys, the sequence will be performed
i
n every mode.
Code upgrade technology
Your ONE FOR ALL KAMELEON 8 also offers a Code upgrade technology.
T
his technology gives you the possibility to add codes to the memory. If your
d
evice uses a particular code which is not found in the KAMELEON 8 memory
(using the “Direct code set up” on page 12 or the “Search Method” on page
13) you may use the ”Code Upgrade Technology” (see page 24). Thanks to this
t
echnology your KAMELEON 8 will never become obsolete.
Note: when inserting the batteries the KAMELEON 8 will be in
“demo-mode (showing several screens). The KAMELEON 8 will go
out of demo-mode automatically as you set it up.
Your KAMELEON 8 requires 4 AAA/LR03 alkaline batteries.
1. Unscrew the battery door using a coin.
2. Insert the batteries with the positive end (+) upwards.
3. Replace the battery door back into position.
Low Voltage Indicator
As soon as the batteries run out of power the KAMELEON 8 will indicate this.
The IR indicator will flash 5 times whenever you press a key and you cannot
access programming mode.
Please make sure to replace the batteries with 4 new AAA/LR03 alkaline
batteries.
About Your KAMELEON 8
Batteries
To Next Page
Loading...
