Battery Tester B70
1
BATTERY ANALYZER B70
Graphic Instructions
How To Operate
3-1. Battery Test
3-2. Alternator Test
3-3. Crank Motor Test
Battery Spec Charts
This machine is for 12V & 24V Lead-Acid vehicle battery.
Please don’t store the machine in high temp or humidity place. It’ll
damage the machine.
The working voltage range is 9V~35V DC.
Please operate after turn on the headlight 3~5 minutes to clean the
surface voltage when the battery was just full recharged.
The bad connect cable between 2pcs of 12V battery (24V system) will
cause the wrong result. Please check individual battery to ensure.
2. Graphic Instruction
1. Monitor Zone: Show Functions & Information
2. Function Zone: Input Data & Select Functions
1. Select: Press Up/Down/Left/Right to input data or select function.
To Next Page
Need help?
General
