Need help?Do you have a question about the OneAudio OpenRock Pro and is the answer not in the manual?
General| Type | Open-ear |
|---|---|
| Driver Size | 16.2 mm |
| Bluetooth Version | 5.2 |
| Water Resistance | IPX5 |
| Battery Life | 19 hours |
| Driver Type | Dynamic |
| Frequency Response | 20Hz - 20kHz |
| Impedance | 16 ohms |
| Charging Time | 1.5 hours (earbuds), 2 hours (charging case) |
Earbuds power on automatically when the case opens or by holding the touch control. They power off when closed or by holding the touch control for five seconds.
Open case, remove earbuds, place back, close lid. Wait 10s, open lid. White light flickers. Search 'OpenRock S' in Bluetooth.
Place earbuds in case, keep open. Hold case button for 5s. Indicator flashes. Choose 'OpenRock S' from Bluetooth list.
Control earbuds by pressing the multitouch area: answer/hang up/play/pause music, reject calls, skip songs, activate voice assistant, switch sound modes.
When 10 minutes of playback remain, the LED flashes red twice every five minutes and a voice prompt says 'Low battery'.
Four white LED indicators on the charging case show five battery levels: 0%, 25%, 50%, 75%, 100%.
Place earbuds in the charging case. The earbuds LED indicator will remain on for two seconds. Close the lid to charge.
Plug the charging cable into the case's charging port. The LED indicator on the case will flash during charging.
To Next Page