7
Washing Overview
1 2 3 4
Washing half-way drain Cleaning Drain
Step 1: Washing
1. Filling water: Adjust to the expected water level with the handle of water level adjuster.
2. putting in washing powder: Selecting washing time.For the detailed information, please
refer to the guide for customers.
3. Putting in washing clothes: The clothes put into the tub would decrease the water level.
Add more water in time if necessary.
4. Selecting water ow: Select corresponding water ow.As for the details,please refer to
the guide for customers. After the washing ends, discharge water.
Attention: If there is amount of water in the tub, it would spill out of the tub.
In order to prevent damage or deforming of
washings,better to tie up some long washings, such
as skirts or pull up all zippers. Pretreating method
just as the gure shown. All pockets should be emp-
ty. take coins,nail etc out of them. Hairy balls,collars
should be turned inside. Fast colorwashings should
be washed separately.
Step 2: Half-way Drain
1. Move the washings into drain tub.The bigger washings such as sheets and towel covers, should
be orderly pressed onto the bottom of tub.
2. Close the lid properly and tightly less accident would happen.
3. Close both the inside and outside lids of the drain tub, then lay down the discharging tube.
4. According to the amount of washings. adjust the drain time.
Step 3: Spinning
1. Move washing into drain tub,larger washings such as bed sheets, towel covers,should be put
on the bottom of the tub, otherwise, greater vibrations would be caused as a result, and that
would aect the drain eciency.
2. Correctly press the pressing lid. Otherwise the washing would jump out and cause the trouble.
3. Close both inside and outside lids of drain tubs,lay down the discharging touble.
4. When nose is heard, it indicates that washings are placed on one side. Open the lid and rear-
range the washings orderly, then restart drain.
To Next Page
Loading...
