oneConcept 10006739 - Step 4: Draining; Washing Instructions; Directly Dissolving Washing Powder; Washing Method for Woolen Fabric

8
During drain when you open the outside lid, the drain tub immediately stops. If you want to drain
and rise at the same time,you should rst lay down the discharging tube and then rise.lf you do not
drop the tube,plenty of water would accumlate in drain tub, which would probably stop the drain.
Step 4: Draining
1. Discharging water completely.
2. Pull the plug out of the socket.
3. Open the lid and tub dry in the air.
4. Take out the de-hair device inside the machine and clean it.
Washing Instructions
Directly Dissolving the Washing Powder
1. Put in washing powder when the water level is low.
2. Choose a program.
3. Start the machine and sturthe water for 1 min.
4. After the washing powder dissolves, put in washings and introduce water to expected level.
5. Select correct washing time.
Washing Method for Woolen Fabric
For ne woolen fabric, the purely made of rabbit long hairs and wool. Don‘t wash them
directly in the tub.
1. Select water level for introducing water inlet; put warm water of below 50°C and select
proper water level.
2. Putting in washing agent:for the washing agent, please refer to washing agent for woo-
len fabric. In order nit to damage the fabric of pure animal hairs. Please use neutral
washing agent without ferment.
3. Putting in washings: woolen washings should be put into the net and washed on their
reverse sides.
4. Washing: wash them ow for 2min then introduce water to rinse them for 2min, take
them out,atten them and keep them in good shape. Don‘t dry them in the sun but dry
them in cloudy days.
Cleaning and Care
• Please pull the plug out of the socket (don‘t touch the socket when your hands are wet) and
put it at the correct position.
• After discharging the water in the tub,please move the switch from discharge to standard.
• Clean the de-hair device: Take out the de-hair set,dismantle it with a nger pressing the
inside bottom. Put the de-hair set in water to clwan. After clwaning,restore the de-hair
device,insert it into the slat wnder the water level side board. A click should be heard.