Key Magic®
2
2
How to reset a key to obtain its original function?
1) Select the corresponding device mode (e.g. tv).
2) Press and hold magic for 3 seconds until a mode indicator (Blue LED)
stays lit.
3) Press 9 9 4.
4) Press the corresponding key (e.g. red) twice.
Congratulations! You have successfully programmed the “I/II (mono/streo)”
function from your original remote control onto your ONE FOR ALL remote
control. NOW whenever you press the “red key” (in tv mode) you will obtain the
“I/II (mono/streo)” function.
P
ress 9 9 4.
-
-> The blue LED will blink twice.
3
4
Enter the 5-digit function-code provided by Customer Service.
(
e.g. 00123)
--> The blue LED will blink twice.
5
Press the key to which the function will
be assigned (e.g. red key).
E
xample: How to get the “I/II (mono/stereo)“ function from your original LOST or
BROKEN remote onto the “red key” on your ONE FOR ALL remote control.
K
ey Ma
gi
c
®
e.g.
Original
LOST
or
BROKEN
remote
K
ey Magic® is an exclusive ONE FOR ALL feature. The design of the ONE FOR ALL ensures that many functions of your original remote control can be operated - even those that do not have
t
heir own key on the ONE FOR ALL keypad. Frequently used functions can be assigned to a key of your choice using the Key Magic® feature of your ONE FOR ALL. In order to program a certain
function with Key Magic® you need to know the corresponding function code. As the function codes vary with different types of devices, they cannot be found in the manual. You can request
y
our function codes through our consumer service help-line or by letter, fax or e-mail.
W
hen you contact us please make sure to mention the following:
• The Current code you are using (see “What is my Set Up Code again?” )
•
Device-type, Brand & Model-number of the corresponding device.
•
Model-number of the original LOST or BROKEN remote control.
• How the function was labeled on your original remote control.
then;
Customer Service will provide you:
• A function-code (5-digit) for every requested function.
Once you obtain your function code(s) from customer service, programming
t
he code is easy:
x2
P
ress and release
the magic key.
1
Press and hold magic for 3 seconds until a mode indicator (Blue LED) stays lit.
3 sec.
To Next Page
Loading...
Need help?
General