Press the key to which
the function will be
assigned (e.g. -/-- key).
Macro
3
Congratulations! You have successfully programmed a macro on the “-/--” key.
N
OW, when you press the -/-- key:
1st: the TV will switch ON.
2
nd: the TV will switch to EXT 1
3
rd: the TV will switch to EXT 2.
The remote will do this in every device mode whenever you press the “-/--” key.
EXT 2
Command 1: TV ON
Command 2: AV (Ext.1)
Command 3: AV (Ext.2)
Press the -/-- key
Y
ou can program your ONE FOR ALL to issue a sequence of commands at the press of one single key. Any sequence of commands you regularly use can be reduced to one key press for
y
our convenience.
For example, you may want to create a macro that will switch ON your TV and then go dirtectly to
E
XT 2 for your Playstation.
1st command: TV --> POWER (ON)
2nd command: AV --> EXT 1 (Digital Receiver Box)
3
nd command: AV --> EXT 2 (Playstation)
To set up the Macro mentioned above on the e.g. “-/--” key on your ONE FOR ALL:
1
2
P
ress and hold magic for 3 seconds until a mode indicator (Blue LED) stays lit.
Press 9 9 5.
--> The blue LED will blink twice.
3
4
5
C
o
m
m
a
nd 3
How to reset the macro key to obtain its original function?
1) Press and hold magic for 3 seconds until a mode indicator (Blue LED)
stays lit.
2) Press 9 9 5.
3) Press the corresponding macro key (e.g. the -/-- key).
4) Press and hold magic key for 3 sec. --> The blue LED will blink twice.
Press the POWER key
x2
3 sec.
6
Press and hold magic for 3 seconds --> The blue LED will blink twice and then switch off.
3 sec.
Press the AV key twice (as you
would to go to EXT 2)
x2
Ext.1:
Digital
Receiver Box
Ext.2:
Playstation
To Next Page
Loading...
Need help?
General