Why is my Oneida Air Systems Plumbing Product losing air volume?
Low air volume in your Oneida Air Systems Plumbing Product is often due to a system clog. First, clean your vacuum and its filter according to the manufacturer's specifications. Then, inspect all hose connections for any blockages within the hose.
What to do if the hose keeps pulling off my Oneida Air Systems Dust Deputy Low-Pro Plumbing Product?
If the hose keeps pulling off your Oneida Air Systems Plumbing Product, it's likely due to loose hose connections. Here are a few possible solutions: 1. Use flexible couplers if you have varied hose diameters. These can be found at local hardware stores in the plumbing section. 2. Secure the hose with a hose clamp. 3. Increase the friction fit by wrapping the inlet and outlet of the Low-Pro with a layer of electrical tape. 4. Use a sheet metal screw to further secure the hose.
Why is my Oneida Air Systems Plumbing Product drum collapsing?
A collapsing drum in your Oneida Air Systems Plumbing Product is caused by blocked airflow. Make sure the end of the hose isn't blocked to resolve this issue.
What to do if material is not dropping into the dust container of my Oneida Air Systems Plumbing Product?
If material isn't dropping into the dust container of your Oneida Air Systems Plumbing Product, it could be due to collecting large, bulky material that tends to swirl. To resolve this, try restarting the system or temporarily cutting off airflow to allow the material to drop down.
General| Brand | Oneida Air Systems |
|---|---|
| Model | Dust Deputy Low-Pro |
| Inlet Size | 2.5 inches |
| Outlet Size | 2.5 inches |
| Type | Cyclone Separator |
Critical safety guidelines for operating the Dust Deputy, including handling flammable dust and proper ventilation.
Instructions for connecting the Dust Deputy to a wet/dry vacuum using the Tether Pack components.
Important warnings regarding dust explosiveness, chemical hazards, and proper system installation and use.
To Next Page
